Table of Contents
Advertisement
2 Connect the serial interface cable to the imager.
Note: Do not connect the cable to your computer
yet.
3 Scan these bar codes in order:
Terminal ID
0
Save
The imager beeps twice during the configuration process.
4 Turn off power to the computer.
5 Connect the serial interface cable to the computer.
6 Turn on power to the computer.
7 Open your application.
1470B Imager Quick Start Guide
0
0
9
Advertisement
Table of Contents
Need help?
Do you have a question about the ScanImage 1470B and is the answer not in the manual?