Table of Contents
Advertisement
2 Connect the keyboard wedge interface cable to the imager.
Note: Do not connect the cable to your computer
yet.
3 Scan these bar codes in order:
Terminal ID
0
Save
The imager beeps twice during the configuration process.
4 Turn off power to the computer.
5 Disconnect the keyboard cable from the back of the
computer.
6 Connect the computer and the keyboard to the keyboard
wedge interface cable.
7 Turn on power to the computer and wait for it to boot.
8 Open a keyboard application, such as Notepad.
1470B Imager Quick Start Guide
0
3
7
Advertisement
Table of Contents
Need help?
Do you have a question about the ScanImage 1470B and is the answer not in the manual?