Advertisement
Available languages
Available languages
TECHNICAL DATA
Detection function data
Maximum measurement depth*
Moisture range
Laser pointer data
Measurement accuracy
Units
Measuring range (without reflector)
Measurement time
Laser type
Automatic laser shutdown
Measurement memory
General parameters
Automatic shutdown
Type of screen
Type and battery life
Dimensions
Working temperature range
Storage temperature range
* The detection results are affected by the material, shape and size of the detected object, as well as by the material and condition of
the detected surface; If the cable is not live, the depth of the probe will be reduced.
** Under good measurement conditions (good measuring surface, room temperature) the measurement error may be up
to 0.25 mm/m; under bad measurement conditions (such as too much ambient light, too large or too small a diffuse reflectance of
the point to be measured, too much temperature difference, etc.) the error may be up to ± 10 m.
*** In case of strong daylight or weak target reflection, use a reflector!
NOTE
Do not allow moisture to penetrate the detector and sunlight to fall directly into the device.
Rapid changes in ambient temperature can cause incorrect results.
Using or operating a transmitter, such as a microwave oven near the detector, can affect the results.
For best scan results:
- Avoid jewellery such as rings or watches when using detectors. Metals can cause inaccurate testing.
- Move the tool evenly to the surface without lifting or changing the applied pressure.
- When scanning, tools must always touch the surface.
- Make sure that the fingers of the hand holding the tool do not touch the scanned surface.
- Do not touch the detector or scanned surface with your other hand or any other part of your body.
- Always test slowly for maximum accuracy and sensitivity.
Adres producenta/ Adresse des Herstellers/ Manufacturer's Address/ Адрес производителя
GTV Poland Sp. z o.o. Sp. k., ul. Przejazdowa 21, 05-800 Pruszków
Ferrous metals
Non-ferrous metals (Cu)
Copper wires Cu (≥mm
)
2
Wood Profiles
Metals
Other materials
±5mm**
m/in/ft
0.05-40m***
0.3-4 seconds
620~670nm,<1mw
20 seconds
last 30
After 5 minutes
1.8 inch, colour
400mAH, lithium, approximately 5000 measurements
135*60*25mm
0 C° ~ 40 C°
-20 C° ~ 60 C°
100mm
80mm
40mm
20mm/38mm
0-85%RH
0-60%RH
11
Advertisement
