Setting Up; Assembly - Martin Yale my OFFICE PRODUCTS P7500 Instruction Manual

Warning!
Never connect power to the folder until you are ready to set up and operate the
machine. During set up, operation, and maintenance keep hands, hair, loose
clothing, and jewelry away from all moving parts. Serious bodily injury could result.
Service or disassembly of folder should only be attempted with the power
disconnected.

SETTING UP

Assembly

Paper Guides
Insert the Paper Guides into the Paper Tray as shown in Figure 1. You will need to
remove the black plastic nuts and clear spacers from the Guides. Once inserted,
install the clear spacers on the Paper Guides and screw the nuts back onto the
Paper Guides and tighten. The Paper Guides should now be attached to the
machine as shown in Figure 2.
Figure 1
Figure 2
Exit Tray Assembly
To assemble the Exit Tray, you will need a #2 Philips screwdriver, the two Metal
Brackets, and the three Exit Tray Connector Sets (each set contains one top plastic
piece, one bottom plastic piece, and two screws). Assemble each Exit Tray
Connector Set onto the Metal Brackets as shown in Figure 3. Hint: It may be
easier to assemble the middle Connector Set first, as noted below.
5