Martin Yale my OFFICE PRODUCTS P7500 Instruction Manual page 7

1. Loosen the 4 plastic thumbscrews under the feed table (see figure 1 for
thumbscrew location) to loosen paper guides.
2. For standard US 8.5" x 11" paper, move
both paper guides in so that the inside
edges align with the straight marks on
the feed table denoted LS (see figure 5
for mark location). For A4 paper, align
the outside edges of the paper guides
with the straight marks denoted A4.
Tighten both thumbscrews (Note: Do
not over tighten thumbscrews).
3. Slide a single piece of paper between the paper guides, check for:
a. Pinching-the paper should slide freely between the paper guides with a
small amount of clearance to feed freely. Loosen thumbscrews and adjust
paper guides if necessary to correct. Setting the paper guides too tight
will result in feed hesitation.
b. Skewing-the paper should be exactly square to the feeding roller. Loosen
thumbscrews and adjust paper guides if necessary to correct.
Fold Table Pin:
Front slots on Fold Tables go around pins.
LS
Paper guides aligned to LS marks
Figure 6: Bottom view of installed Fold Table
7
LS
Figure 5:
Silver Tie Rod:
Cutouts on Fold Table
rest on top of Tie Rods.