Table of Contents
Advertisement
Available languages
Available languages
Hoop-and-loop tape
Place the device on the floor and attach the supplied top to the hoop-and-loop tape going around the unit. Make
sure that the cloth cannot be drawn into the intake of the ventilation fan. Connect the device to the mains with the
power plug. The fan starts running and the lamps will light up. For a more convenient operation, connect the device
to a mains outlet which is switchable.
Rigging
Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure that the
device is installed securely and cannot fall down. The installation must be carried out by a specialist
who is familiar with the hazards and the relevant regulations.
The device may be fastened to a truss or similar rigging structure. The device must never be fixed swinging freely
in the room.
1
The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2
Block access below the work area and work from a stable platform when installing the device.
3
Use rigging hardware that is compatible with the structure and capable of bearing the weight of the device.
Please refer to the "Accessories" section for a list of suitable rigging hardware.
4
Secure the device with a safety bond or other secondary attachment. This secondary safety attachment must
be sufficiently dimensioned in accordance with the latest industrial safety regulations and constructed in a way
that no part of the installation can fall down if the main attachment fails. An appropriate eyelet is mounted on
the device for fixation of the safety bond. Fasten the safety bond in such a way that, in the event of a fall, the
maximum drop distance of the device will not exceed 20 cm.
5
After installation, the device requires inspections periodically to prevent the possibility of corrosion, deformation
and looseness
SETUP
WARNING!
10 • EN
Advertisement
Chapters
Table of Contents
