Operating Elements And Connections; Setup; Mounting; Linking Several Devices - EuroLite PST-9W User Manual

Mounting

Fasten the device to a wall or ceiling with the mounting bracket. Always choose screws and plugs which are
suitable for use in your wall/ceiling and have enough holding power. Fasten the device in such way that it will not
fall down. To align the device, release the fixation screws at the mounting bracket, adjust the desired inclination
angle and tighten the fixation screws.

Linking several devices

Several fixtures may be interconnected via the IN and OUT jacks and operated in sync (section Master/Slave
Operation). Connection cables are included. Note: The first fixture in the chain must not be connected to a DMX
controller.

Connection to the mains

The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts. Connect the
device via the mains cable to a grounded mains socket. Thus the unit is switched on. To switch off the unit,
disconnect the power plug. Notes: Do not connect the unit to the mains voltage via a dimmer. For a more
convenient operation, use a mains outlet which is switchable.

OPERATING ELEMENTS AND CONNECTIONS

SETUP

1) RGB LED
2) Monting bracket
3) Fixation screw
4) DIP switches
5) DMX connectors
6) Power cord