Setup; Placing The Unit; Dmx512 Control - EuroLite LED PARty User Manual

Placing the unit

The device may be placed on the floor by unfolding the brackets or mounted to the wall or ceiling via one of the
brackets. Always choose screws and plugs which are suitable for use in your wall/ceiling and have enough holding
power. Fasten the device in such way that it will not fall down. To align the device, release the fixation screws at
the mounting bracket, adjust the desired inclination angle and tighten the fixation screws.

DMX512 control

DMX Controller
A DMX512 data link is required in order to control the device via DMX. The device provides 3-pin XLR connectors
for DMX connection.
1 Connect the output of your DMX controller to the DMX input DMX IN of the light set with a DMX cable.
2 Connect the DMX output DMX OUT of the light set to the DMX input of the next unit in the chain. Always
connect one output to the input of the next unit until all units are connected.
3 At the last unit, the DMX cable has to be terminated. Plug the terminator with a 120 Ω resistor between Signal
(–) and Signal (+) in the DMX output of the last unit.
4 If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended to
insert a DMX level amplifier to ensure proper data transmission.
XLR connection:
Wireless DMX transmission with QuickDMX
The device features an alternative DMX input for a QuickDMX receiver (sold separately). CRMX and WDMX
receivers are compatible and can also be used. The connector allows a DMX control signal to be transmitted
wirelessly to the device, eliminating the need for complex wiring to the DMX controller. The connector is designed
as a USB port which provides the required 5 V operating voltage for the receiver.
Occupation of the USB port:

SETUP

Device 1
Start Address 1
Program
Chase32 Step100
Device 2
Start Address 8
23 • EN
Device 3
Start Address 15