Temperature Indicator; Temperature Regulation; Frostmatic Function; High Temperature Alarm - AEG A75298-SK1 User Manual

6
Control panel

Temperature indicator

The temperature indicator shows several information:
• During normal operation, the temperature indicator shows the current temperature in-
side the freezer (ACTUAL temperature). The ACTUAL temperature is indicated with illu-
minated numbers.
• During temperature adjusting operation, the temperature indicator shows the freezer
temperature currently set (DESIRED temperature). The DESIRED temperature is indicated
by flashing numbers.

Temperature regulation

To operate the appliance, proceed as follows:
1. Set the required temperature by pressing the corresponding temperature regulator. The
temperature indicator will immediately show the DESIRED temperature and the tem-
perature indicator flashes.
2. Each time the temperature regulator is pressed the DESIRED temperature is adjusted
by 1 °C. The DESIRED temperature must be reached within 24 hours.
3. Once the required temperature has been set, after a short period (approx. 5 sec.) the
temperature indicator will show again the current ACTUAL temperature inside the cor-
responding compartment. The temperature indicator will change from flashing to con-
tinuous illumination.
For a correct storage of the food the following temperature should be set:
• -18 °C in the freezer.

FROSTMATIC function

The FROSTMATIC function accelerates the freezing of fresh food and, at the same time,
protects foodstuffs already stored from undesirable warming.
To activate the function, do these steps:
1. Press the FROSTMATIC switch.
2. The FROSTMATIC indicator will light up.
To deactivate the function, do these steps:
1. Press the FROSTMATIC switch.
2. The FROSTMATIC indicator goes out.
The FROSTMATIC function stops automatically after about 52 hours.
If the FROSTMATIC function is switched on the temperature setting may not be changed.

High temperature alarm

Temperature increase in the freezer compartment (for example due to an earlier power
failure or door is open) is indicated by:
• Alarm light flashing
• flashing temperature
• sounding of buzzer
When normal conditions are restored:
• the acoustic alarm will stop
• the temperature value continues to flash
• the Alarm light continues to flash