Switching Off; Selecting Freezing Or Cooling Mode; Temperature Indicator; Temperature Regulation - AEG A85280-GA User Manual

24
Control panel

Switching off

Press the ON/OFF button until a countdown is completed from -3 -2 -1.
The temperature indicator and the Pilot light switches off.

Selecting Freezing or Cooling mode

The appliance can be used as a freezer or a refrigerator compartment.
• To switch over from "Freezing" to "Cooling" mode, press the Alarm reset button and
Temperature regulator - button for a few seconds.
The Temperature indicator shows FC (approx. 5 sec). The changed mode is indicated with
a beep and the DESIRED temperature shows.
• To switch over from "Cooling" to "Freezing" mode, press the Alarm reset button and
Temperature regulator - button for a few seconds.
The temperature indicator shows CF (approx. 5 sec). The changed mode is indicated with
flashing temperature, flashing alarm light, an acoustic alarm and the DESIRED temper-
ature shows.
When switching from "Cooling" to "Freezing" mode the high temperature alarm will go on.
Refer to "High temperature alarm"

Temperature indicator

• During normal operation, the temperature indicator shows the current temperature in-
side the appliance (ACTUAL temperature).
• During temperature adjusting operation, the temperature indicator flashes the appliance
temperature currently set (DESIRED temperature).

Temperature regulation

To operate the appliance, proceed as follows:
1. Set the required temperature by pressing the corresponding temperature regulator. The
temperature indicator flashes the DESIRED temperature.
2. Each time the temperature regulator is pressed the DESIRED temperature is adjusted
by 1 °C. The DESIRED temperature is reached within 24 hours.
Once the DESIRED temperature has been set, after a short period (approx. 5 sec.) the tem-
perature indicator will show again the ACTUAL temperature inside the compartment. The
temperature indicator will change from flashing to continuous illumination.
For a correct storage of the food the following temperature should be set:
• -18 °C in freezing mode
• +5 °C in cooling mode

TURBO FROSTMATIC function

When the appliance is used as a freezer
The TURBO FROSTMATIC function accelerates the freezing of fresh food and , at the same
time, protects foodstuffs already stored from undesirable warming.
To activate the function, do these steps:
1. Press the TURBO FROSTMATIC button.
2. The TURBO FROSTMATIC indicator will light up and the Temperature indicator shows
SF (approx. 5 sec).
To deactivate the function, do these steps: