10. TECHNICAL INFORMATION..................17 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference.
Do not use water spray and steam to clean the • appliance. Clean the appliance with a moist soft cloth. Only use • neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. Do not store explosive substances such as aerosol •...
ENGLISH • Do not change the specification of • Before maintenance, deactivate the this appliance. appliance and disconnect the mains • Do not put electrical appliances (e.g. plug from the mains socket. ice cream makers) in the appliance • This appliance contains hydrocarbons unless they are stated applicable by in the cooling unit.
ENGLISH Mode ON/OFF It is possible to change predefined Mode and Temperature colder button sound of buttons by pressing together for some seconds. Change is reversible. Display F E D A) Timer function E) ChildLock function B) FROSTMATIC function F) MinuteMinder function C) Temperature indicator D) Alarm indicator 4.2 Switching on...
2. Press the Temperature colder or The FROSTMATIC function Temperature warmer button to shuts off automatically after change the Timer set value from 1 to 52 hours. 90 minutes. To switch off the function 3. Press OK to confirm.
ENGLISH 5.4 Removal of freezing WARNING! baskets and glass shelves from In the event of accidental the freezer defrosting, for example due to a power failure, if the The freezing baskets have a limit stop to power has been off for prevent their accidental removal or longer that the value shown falling out.
To remove them, loose the locking pin on each side on the expander roller. If necessary, use a screwdriver. Afterwards pull out both locking pins (1) and pull the glass shelf outwards (2). 6. HINTS AND TIPS 6.1 Normal operating sounds •...
ENGLISH • make sure that the commercially • once defrosted, food deteriorates frozen foodstuffs were adequately rapidly and cannot be refrozen; stored by the retailer; • do not exceed the storage period • be sure that frozen foodstuffs are indicated by the food manufacturer. transferred from the foodstore to the freezer in the shortest possible time;...
7.5 Periods of non-operation 4. Leave the door/doors open to prevent unpleasant smells. When the appliance is not in use for long WARNING! periods, take the following precautions: If the cabinet will be kept on, 1. Disconnect the appliance from ask somebody to check it electricity supply.
Page 13
ENGLISH Problem Possible cause Solution The lamp does not work. The lamp is defective. Contact the nearest Author- ised Service Centre. The compressor operates Temperature is set incor- Refer to "Operation" chapter. continually. rectly. Many food products were Wait some hours and then put in at the same time.
Problem Possible cause Solution The food products' tem- Let the food products temper- perature is too high. ature decrease to room tem- perature before storage. The door has been Open the door only if necessa- opened often. The FROSTMATIC function Refer to "FROSTMATIC func-...
ENGLISH positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm . Ideally, however, the appliance should not be positioned below overhanging wall units. Accurate levelling is ensured by one or more adjustable feet at the base of the cabinet.
9.4 Rear spacers CAUTION! To carry out the following You can find the two spacers in the bag operations, we suggest that with documentation. this be made with another 1. Release the screw. person that will keep a firm 2.
ENGLISH 11. Re-insert the door on the lower hinge pivot . 12. Re-insert the door on the upper hinge pivot slightly tilting the door. 13. Screw the lower hinges. 14. Refit the plinth. CAUTION! Reposition, level the appliance, wait for at least four hours and then connect it to the power socket.
Rising time Hours Voltage Volts 230 - 240 Frequency The technical information are situated in internal side of the appliance and in the the rating plate, on the external or energy label. 11. ENVIRONMENT CONCERNS marked with the symbol...