Configuring The Te 2000 Application; Using Advanced Features; Unsupported Commands And Functions - Intermec CK30 Programmer's Manual

Configuring the TE 2000 Application

Using Advanced Features

Unsupported Commands and Functions

™
TE 2000 5250 Terminal Emulation Programmer's Guide
You can use the terminal's TE 2000 configuration menus to configure
site-specific operational parameters, including UDP Plus, WTP, or TCP/
IP communications, terminal emulation options, and the Main Menu
password. For information about configuring the terminal, see Chapter 4,
"Using the Terminal Emulation Menus."
You can customize the standard TE 2000 program to do the following:
For more information, see Chapter 5, "Customizing Your Configuration."
S Use the auto-login feature to send the same login information each time
you login to the host.
S Display double-byte characters.
S Create a custom parameter set-up file.
S Change the text of terminal emulation configuration menus or system
messages.
S Preinitialize the TE 2000 5250 terminal emulation program
The TE 2000 application for the 2415, 2425, 2435A, 2455, 2475, and
248X Terminals does not support the following commands and functions,
which were supported in previous versions.
End (viewport)
Erase Field
Erase Last Word
Fast Cursor Right or Left Moved the cursor two positions to the right or left rather
Home (viewport)
Reshow
Status
Status line messages
If you scan the bar code for an unsupported command, the bar code data
is read into the terminal. If you press the key sequence for the command,
the sequence is ignored.
Chapter 1
Moved the window/viewport to the end of the last line dis-
played on the TE screen.
Erased all characters in the field where the cursor was posi-
tioned.
Erased all characters from the cursor back to the start of a
word or a space on the screen.
than one.
Moved the window or viewport to the top left corner of the
TE screen.
Resent a screen image from the locally maintained host
buffer to refresh the terminal screen.
Toggled the terminal's screen between the status line dis-
play and the normal field input display.
Reported the operating status of the terminal and host sys-
tem.
—
Getting Started
5