Table of Contents
Advertisement
User Manual EtherCAT Slave / DeviceNet Slave
Document code: MN67E10_ENG
Revision 1.000
Page 11 of 24
Industrial Electronic Devices
ETHERNET:
The updating of the converter must be made using Connector8 of the HD67E10-A1 with at least a Category 5E cable. The maximum length
of the cable should not exceed 100m. The cable has to conform to the T568 norms relative to connections in cat.5 up to 100 Mbps. To
connect the device to an Hub/Switch is recommended the use of a straight cable, to connect the device to a PC/PLC/other is recommended
the use of a cross cable.
ADFweb.com S.r.l.
Advertisement
Table of Contents
Need help?
Do you have a question about the HD67E10-A1 and is the answer not in the manual?