Trycom Technology TRP-C32S User Manual page 17

The TRP-C32S serial port default settings are, baud rate 9600, 8 data bits, no parity, and 1 stop
bit. Hyper Terminal should be used for this type of setup. Hyper Terminal's serial settings are
configured the same as the mentioned default settings of the TRP-C32S and must be set to
VT100 emulation mode. The default settings are used only if they have not been changed
7-2-1 Console Mode Hardware Wiring
7-2-2 Console Mode Software Install
STEP1. Select "Hyper Terminal" WINDOWS Utility
Start ---Accessories---Communications --- Hyper Terminal
STEP2.Select "New Connection" and Enter a name, click "OK"
.
17