Fill With Coolant; Handle - Husqvarna MS360 Operator's Manual

Parallel to the cutting slot and centered in
the cutting slot
• Set the blade to run freely and in its lowest position in
the cutting slot.
• Use an set square and check if the blade is
perpendicular, both front and back edge of the blade
to the conveyor cart anvil and check if the blade is
centered in the cutting slot.
• To adjust the blade, loosen the four screws holding the
support arm.
• Use the adjustment rod to adjust the blade
perpendicular to the conveyor cart anvil.
• Set the blade in the center of the cutting slot.
• Check again that the blade is perpendicular to the
conveyor cart anvil, the whole side of the blade must
be in contact with the set square. Tighten the
adjustment rod and the four screws holding the
support arm.
12 – English
ASSEMBLING AND ADJUSTMENTS

Fill with coolant

Make sure the water level is always above the low walls
where the pump is located.
• Connect the power cable for the water pump to the
plug on the machine.

Handle

The position of the handle of the cutting arm is reversible
to give an ergonomically correct position for both right and
left-handed persons.