Husqvarna MS360 Operator's Manual page 11

45° ° ° °
• Loosen the locking knob for depth setting and raise up
the cutting arm.
• Loosen the lock knob for the mitre (1). Angle the
cutting arm until the screw (2) bottoms at the guide
end plate.
2
• Check the angle, 45° and if needed loosen the lock
nut and adjust the screw (2) until it bottoms at the
guide end plate.
2
ASSEMBLING AND ADJUSTMENTS
1
45
22,5° ° ° °
• Loosen the locking knob for depth setting and raise up
the cutting arm.
• Loosen the lock knob for the mitre (1). Angle the
cutting arm until the markings for 22,5° are opposite
each other (2).
• Check the angle, 22,5° and if needed adjust the
triangular shaped marking (2).
2
1
2
1
22,5
67,5
English
–
11