Maintenance Table; Power Supply - Stiga C 340 Operator's Manual

7. MAINTENANCE TABLE

MACHINE
Check all fasteners ; Safety checks/check controls; Check the rear discharge guard; Check the
grass catcher; Check the cutting means.
General cleaning and inspection; Checking for any damage to the machine. If necessary,
contact the authorised service centre.
Replacing the cutting means.

POWER SUPPLY

Check the integrity of the power cable and good condition of the sockets.
*** The operation must be carried out by your Dealer or a Authorised Service Centre
8. DIAGNOSTICS
What to do if ....
Problem description
1. The electric lawnmower doesn't work
The machine has no power
supply
2. The electric lawnmower trips the power supply.
The mains socket
amperage is insufficient
Other electrical appliances
are being used
3. The cut grass is not collected in the grass catcher
The cutting means has
received a knock
The inside of the chassis
is dirty
Intervention
Corrective Action
Check the electrical
connection
Connect the machine
to a mains socket with
sufficient amperage
Do not connect other
appliances to the same
mains socket at the same
time
Have the cutting means
sharpened or replace it
Check the fins that direct
the grass towards the
grass catcher
Clean the inside of the
chassis to ease the grass
discharge towards the
grass catcher
4. Mowing is difficult
The cutting means is not in
good condition
5. The machine starts to vibrate abnormally
Damaged or loose parts
6. The motor shuts down whilst working
The thermal protection has
tripped due to overheating
of the motor.
For any doubts or problems, please do not hesitate to con-
tact your nearest Customer Service Centre or Your Dealer.
6
Frequency
Before use
After each use
-
Before use
Have the cutting means
sharpened or replace it
Stop the machine and
disconnect the plug from
the socket.
Inspect for damage
Check for and tighten any
loose parts
Have all checks, repair
work and replacements
carried out by a specialized
Centre only
Stop the machine and
disconnect the plug from
the socket. Always make
sure the air intakes are free
of debris.