Cleaning
ATTENTION! PROPERTY DAMAGE!
►
Do not use aggressive, chemical or abrasive cleaning agents . These could
damage the outer surfaces of the appliance .
Emptying the dirt container and cleaning the filter
NOTE
►
To achieve the best results, empty the dirt container i and clean the HEPA
filter z regularly .
►
If you need a new HEPA filter z, please contact our service department
(see section "Ordering spare parts") .
1) If you have not already done so, disconnect the appliance from the mains
adapter 0 or lift it off the wall bracket 7 .
2) To open the dirt container i, press the release button e and remove the
dirt container i from the appliance .
3) Remove the filter holder u together with the HEPA filter z from the dirt
container i by pulling both straight out of the dirt container i .
4) Empty the dirt container i .
5) Remove the HEPA filter z from the filter holder u by turning it anticlockwise
towards the
6) Tap out the HEPA filter z and the filter holder u over a rubbish bin . If
necessary, you can rinse out the filter holder u and the HEPA filter z with
fresh water . Before replacing the parts ensure that they are completely dry .
Do not dry the HEPA filter z with hot air .
7) Reinsert the filter holder u into the dirt container i . Make sure that the filter
holder u is straight and that the rubber lip seals the dirt container i .
8) Insert the HEPA filter z into the filter holder u so that the catches on the
HEPA filter z fit into the corresponding recesses on the filter holder u .
The arrow on the HEPA filter z must be aligned with the arrow on the filter
holder u . Turn the HEPA filter z clockwise towards the
9) Replace the dirt container i on the motor unit r:
–
First, place the contacts on the underside of the dirt container i onto
the contact pins on the underside of the motor unit r . This pushes the
two catches on the motor unit r into the recesses on the dirt container i .
–
Press the upper side of the dirt container i against the upper side of
the motor unit r so that the catch audibly engages . The dirt container i
is now firmly seated on the motor unit r .
■
54
│
GB │ MT
symbol and pulling it out .
symbol .
SAST 18 A1