Operation; Using The Hand Element With The Handle; Using The Hand Element; Cleaning And Care - Silvercrest SHSS 12 C2 Operating Instructions Manual

Operation

ATTENTION! MATERIAL DAMAGE!
► The suction opening must always be open and
unblocked. Blockages lead to overheating and
damage to the motor.
► Do not vacuum shag pile carpet with the floor
nozzle. The rotary brush
the carpet and block!
NOTE
► Make certain that the dust filter
coarse filter are always inserted before
using the appliance.
► As soon as the suction power of the appliance
begins to diminish noticeably, connect the
appliance to the charger
Using the hand element with the
handle
1) Insert the hand element
element recess as described in the chapter
"Assembly/disassembly".
2) Fold out the grip
release and at the same time pulling the
grip upwards.
3) Switch on the appliance using the on/off
switch . The LED lamp
will illuminate and the rotary brush
turning.
4) Guide the floor nozzle over the area to be
vacuumed. Hold the grip
nozzle moves smoothly over the floor.
5) Press the on/off switch
finished vacuuming. The rotary brush
and the LED lamp
SHSS 12 C2
can get caught in
and the
.
into the hand
by pressing the "Grip"
on the floor nozzle
starts
so that the floor
when you have
stops
goes out.

Using the hand element

1) Remove the hand element
element recess as described in the chapter
"Assembly/disassembly".
2) If required, attach the crevice tool
brush nozzle .
3) Set the on/off switch
desired areas.
4) When you have finished vacuuming, press the
on/off switch again.

Cleaning and care

WARNING! RISK OF INJURY!
► Always disconnect the charger
mains socket and remove the barrel jack
from the charging socket
before cleaning the cradle
► Always remove the hand element
hand element recess
cleaning the hand element
the rotary brush
To achieve the best results, empty the dirt container
and clean the dust filter
ATTENTION! MATERIAL DAMAGE!
► Do not use abrasive or aggressive cleaning
materials. These could damage the surface
of the appliance!
NOTE
► The LED lamp is maintenance-free.
The LEDs cannot be changed.
from the hand
or the
to start vacuuming the
from the
on the cradle
.
from the
on the handle before
, the handle or
.
after every use.
GB
CY
7