A4. Mount The Microwave Oven - Avanti MOTR14K3S-IS Installation Instructions Manual

A4: MOUNT THE MICROWAVE OVEN
FOR EASIER INSTALLATION AND PERSONAL SAFETY,
WE RECOMMEND THAT TWO PEOPLE INSTALL THIS
MICROWAVE OVEN.
IMPORTANT:
DO NOT GRIP OR USE HANDLE DURING INSTALLATION.
IF FILLER BLOCKS ARE NOT USED, CASE DAMAGE MAY OCCUR FROM OVER TIGHTENING SCREWS.
NOTE:
If your cabinet is metal, use the nylon grommet around the power cord to prevent cutting of the cord.
We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf.
When mounting the microwave oven, thread power cord through hole in the bottom of the top cabinet. Keep it tight
throughout steps 1 – 3, do not pinch or lift oven by pulling cord.
nylon grommet
metal cabinet
The filler block is only used for recessed cabinet and front overhand cabinets(see types of cabinet previously explained in
this manual), you should place the filler block to the cabinet bottom before installing the oven.
6) Tighten the outer screws to the top of the microwave oven. (During tightening screws, hold the microwave oven
in place against the wall and the top cabinet.
Step – by – Step Installation Guide
power cord
1) Lift microwave, tilt it forward, and hook slots at back
power cord
2) Rotate front of oven up against the cabinet bottom.
hole
3) Attach the microwave oven to the top cabinet.
4) Insert 2 self-aligning machine screws (1/4" x 20 x 3")
5) Temporarily secure the oven by turning the screw at
Cabinet Front
Cabinet Bo�om
Self-Aligning machine Screw
Microwave Oven top
16
bottom edge onto four lower tabs of the mounting plate.
through the outer top cabinet holes.
least two full turns after the threads have engaged. (It
will be completely tightened later.) Be sure to keep
power cord tight. Be careful not to pinch the cord,
especially when mounting flush to the bottom of the
cabinet.
Turn two full turns on each screw.
self-aligning
machine sc rew
Washer
Filler Block
Equivalent to
Depth of Cabinet
Recess
washer