A2. Use Top Cabinet Template For Preparation Of Top Cabinet; A3. Check For Proper Damper Operation - Avanti MOTR14K3S-IS Installation Instructions Manual

Step – by – Step Installation Guide
A2: USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET
You need to drill holes for the top support screws, a hole
large enough for the power cord to fit through, and a cutout
large enough for the exhaust adaptor.
• Read the instructions on the TOP CABINET TEMPLATE
• Tape it underneath the bottom of the top cabinet.
• Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes in the
cabinet
A3: CHECK FOR PROPER DAMPER OPERATION
• Place the microwave in its upright position, with the top of
Exhaust Adaptor(absent on models shipped for recircula�on exhaust)
the unit facing up.
Blower Plate
• The exhaust adapter only used for top exhaust and
outside back exhaust. It is not included on those units
Damper
shipped for recirculation exhaust only.
• Make sure tape security the damper is removed and
Back of microwave
damper pivots easily before mounting microwave.
• Attached the exhaust adapter to the blower plate by
sliding it into the guides. Secure the adapter with one
sheet metal screw (provided).
Screw
Guide
• You will need to make adjustment to assure proper
alignment with your house exhaust duct after the
Blower Plate
microwave is installed.
Guide
15