Table of Contents
Advertisement
Available languages
Available languages
INTRODUCTION
This installation guide will show you how to install your new over-the-range microwave
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT – Save these instructions for local inspector's use.
• IMPORTANT - Observe all governing codes and ordinances.
• Note to the installer – Be sure to leave these instructions with the consumer.
• Note to the consumer – Keep these instructions for future reference.
• Skill Level – Installation of this appliance requires basic mechanical and electrical skills.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered under the warranty.
IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT – PLEASE READ CAREFULLY. FOR PERSONAL SAFETY, THIS APPLIANCE
MUST BE PROPERLY GROUNDED TO AVOID SEVERE OR FATAL SHOCK.
This product requires a three-prong, properly grounded outlet for safe operation. If not properly
grounded, or if the outlet box does not meet electrical requirements noted (under ELECTRICAL
REQUIREMENTS), a qualified electrician should be employed to correct any deficiencies.
The power cord of this appliance is equipped with a three-prong (grounding) plus which mates with a standard three-
prong (grounding) wall receptacle to minimize the possibility of electric shock hazard from this appliance.
Where a standard two-prong wall receptacle is encountered, it is very important to have it replaced with a properly
grounded three-prong wall receptacle installed by a qualified electrician.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT, DEFORM, OR REMOVE ANY OF THE PRONGS FROM THE POWER
CORD.
DO NOT USE WITH AN EXTENSION CORD.
NOTE: For easier installation and personal safety, it is recommended that two people install this product.
CAUTION:
For personal safety, remove the house fuse or open the circuit breaker before beginning installation to avoid sever or fatal
shock injury.
For personal safety, the mounting surface must be capable of supporting the cabinet load, in addition to the added weight
of this 50-70 pound (22.6 – 31.7 kilogram) product, plus addition oven loads of up to 50 pounds (22.6 kgs) for a total
weight of 100 – 120 pounds (45.2 – 54.3 kgs).
For personal safety, this product cannot be installed in cabinet arrangement such as an island or a peninsula. It must be
mounted to BOTH a top cabinet and a wall.
ELECTRICAL REQUIREMENTS
The product rating for your microwave is 120 V AC, 60 Hz, 13.5 Amps and 1.5 Kilowatts. This product must be connected
a supply circuit of the proper voltage and frequency. Wire size must conform to the requirements of the National Electrical
Code or the prevailing local code for this kilowatt rating. The power supply cord and plug should be brought to a separate
20 ampere branch circuit single grounded outlet. The outlet box should be located in the cabinet above the microwave
oven. The outlet box and supply circuit should be installed by a qualified electrician and conform to the National Electrical
Code or the prevailing local code.
General Information
3
Ensure proper ground
before use.
Advertisement
Table of Contents
