Installation Instructions; Before Using Your Microwave Oven; Installation Of Your Microwave Oven; Safety Precautions - Avanti MOTR13D3S Instruction Manual

INSTALLATION INSTRUCTIONS



BEFORE USING YOUR MICROWAVE OVEN

•
Remove the exterior and interior packing.
•
Check to be sure you have all of the following parts:
•
Glass Tray
•
Turntable Roller Assembly (Roller or Roller Ring)
• Instruction Manual / Installation Manual
•
Inspect the oven after unpacking for any visual damage such as:
•
Misaligned Door
•
Damaged Door
•
Dents or Holes in Door Window and Screen
•
Dents in Cavity
If any of the above is visible, DO NOT use the oven.


INSTALLATION OF YOUR MICROWAVE OVEN

SEE FULL INSTALLATION INSTRUCTIONS IN INSTALLATION MANUAL
•
Do not block air vents. If they are blocked during operation, the oven may overheat and eventually cause
oven failure.
•
Poor television reception and radio interference may result if the oven is located close to a TV, radio, antenna,
or antenna wire. Position the oven as far from them as possible.
•
Clean the interior surface with lukewarm water using a soft cloth.
•
Keep the oven away from hot air, steam or splashing liquids when choosing a place to locate it, otherwise, the
unit's operation may be adversely affected, causing it to break down.
•
Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
•
Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any circumstances
cut or remove the third (ground) prong from the power cord. Any questions concerning power and or
grounding should be directed toward a certified electrician or an authorized Avanti Products service center.
•
DO NOT place anything on the top of the oven.
•
DO NOT remove the turn-table drive shaft.


SAFETY PRECAUTIONS

PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO
(a) Do not attempt to operate this oven with the door-open since open-door operation can result in harmful
exposure to microwave energy. It is important not to defeat or tamper with the safety interlocks.
(b) Do not place any object between the oven front face and the door or allow soil or cleaner residue to
accumulate on sealing surfaces.
(c) Do not operate the oven if it is damaged. It is particularly important that the oven door close properly and that
there is no damage to the : (1) Door ( bent ), (2) Hinges and latches ( broken or loosened ), (3) Door seals
and sealing surfaces.
(d) The oven should not be adjusted or repaired by anyone except properly qualified service personnel.
EXCESSIVE MICROWAVE ENERGY
Installation Hardware Kit
(Detailed Breakdown In Installation
Manual)
6