Ebyte E95-DTU User Manual page 18

Chengdu Ebyte Electronic Technology Co.,Ltd.
1
Channel Control (CH)
RE
05H 0-83 respectively represent a total of 84
G2
channels
7
0
1
6
0
1
5
0
1
4
Rea
0
RE
06H d/wr
G3
ite
1
3
0
1
Copyright ©2012–2022，Chengdu Ebyte Electronic Technology Co.,Ltd.
1 10dBm / 21dBm
Enable RSSI bytes
disabled (default)
Start
transfer method
transparent transmission (default)
fixed point transmission
Relay function
Disable relay function (default)
Enable relay function
LBT enable
disabled (default)
Start
WOR Mode Transceiver Control
WOR receiver (default)
The transceiver is turned on, and when
transmitting data, a wake-up code for a
certain period of time is added.
WOR transmitter
The radio cannot transmit data, and
works in WOR monitoring mode. The
monitoring period is shown below
(WOR period), which can save a lot of
power consumption.
E95-DTU(900SLxx-485) User Manual
decrease in the same proportion as the
power decreases.
Actual frequency = 410.125 + CH *1M
When enabled, the
wireless data and outputs it through the
serial port TXD, followed by an RSSI
strength byte.
During fixed-point transmission, the
radio will identify the three bytes of
serial port data as: address high + address
low + channel, and use it as the wireless
transmission target.
After the relay function is enabled, if the
target address is not the radio itself, the
radio will start a forwarding;
In order to prevent data return, it is
recommended to use in conjunction with
fixed-point mode; that is, the destination
address and the source address are
different.
After enabling, the wireless data will be
monitored before transmission, which
can avoid interference to a certain extent,
but may cause data delay;
The maximum stay time of LBT is 2
seconds, and it will be issued forcibly
when it reaches two seconds.
Only valid for mode 1;
After the WOR receiver receives the
wireless data and outputs it through the
serial port, it will wait for 1000ms before
entering the WOR again. During this
period, the user can input the serial port
data and return it through the wireless;
Each serial port byte will refresh 1000ms
time;
The user must initiate the first byte
within 1000ms.
radio receives