Table of Contents
Advertisement
Ø38MM STANDPIPE INSTALLATION
1
2
3
4
14
PLUMBING & ELECTRICAL CONNECTION
Install the drain hose support to the
back wall, as close to the underside of
the countertop as possible. Refer to
'Plumbing & electrical considerations' for
minimum install heights.
Pull the hose through the support guide
and rest in standpipe.
Ensure the drain hose does not extend
into water retained in the trap; an air
gap is required to prevent waste water
from siphoning back into the tub.
Ensure the rubber washer is fitted when
connecting the inlet hose to the tap.
Hand-tighten into place.
Using a spanner or pliers, turn a further
180° to secure. Avoiding over-tightening.
Do not turn water supply on. The
Dishwasher must be powered on for the
flood protection feature to be enabled.
Plug product in.
SINK TRAP/WASTE TEE INSTALLATION
1
2
3
4
Install the drain hose support to the
back wall, as close to the underside of
the countertop as possible. Refer to
'Plumbing & electrical considerations' for
minimum install heights.
Pull the hose through the drain hose
support before threading the hose
clamp onto the hose and fitting to
the sink trap. Secure to trap using the
clamp. Ensure hose is routed straight to
the trap.
Unplug or drill out the waste tee before
securing joiner to sink trap or waste tee.
Ensure the rubber washer is fitted when
connecting the inlet hose to the tap.
Hand-tighten into place.
Using a spanner or pliers, turn a further
180° to secure. Avoiding over-tightening.
Do not turn water supply on. The
Dishwasher must be powered on for the
flood protection feature to be enabled.
Plug product in.
Advertisement
Table of Contents
