Table of Contents
Advertisement
PUSH INTO CAVITY
1
2
3
4
Using a flat bladed screwdriver, turn to
raise the leveling feet. Level the rear,
outside legs first followed by the front
legs. Do not adjust the rear middle
leg yet.
Remove both screw covers before
partially pushing the product into the
cavity, pulling the hoses through as you
push to avoid crushing or twisting them.
Take care not to bend the legs.
Push the product from the outside
edges to avoid door damage.
Check the product sits level within
the cavity.
If required, the rear middle leg can be
adjusted from the front of the product
using a 5mm Allen key.
Select desired spacer width and cut
to size. Remove adhesive and fit two
spacers to each side of the product.
Push the product into the cavity from
the outside edges.
SECURE TO CAVITY
1
2
3
Loosely fit 2 x side fixing screws.
If needed, adjust the Dishwasher within
the cavity before tightly securing in
place. Replace the screw covers.
Secure to benchtop using 2 x screws
if possible.
11
Advertisement
Table of Contents
