Fisher & Paykel WH1260F1 Quick Start Manual page 4

Hide thumbs Also See for WH1260F1:

4. After the draining process is complete, replace the plug

into the hose and refit the hose back into the housing.

5. Remove the filter by turning anti-clockwise (refer to A).

Clean and rinse under a tap. Check the pump filter

cavity for any further obstruction.

6. Replace the filter by turning clockwise until the turning

handle stops in the vertical position, and cannot be

turned further (refer to A).

7. Close the filter cover.

Turn filter clockwise until turning handle stops in vertical position and tabs meet

Cleaning the Hoses

Each inlet hose has a filter in it, preventing any solid contaminants in the water from entering your washing machine.

Occasionally you should disconnect the water inlet hoses where they connect to the taps, check these for any build up

of dirt and wash the filters out.

https://producthelp.fisherpaykel.com/au/Wash/Front_Loaders/FabricSmart/WH1260F1/User_Guide_WH1260F1/13_Caring_fo...

Drain residual water

Removing/replacing filter

Updated: Tue, 02 Aug 2022 02:36:29 GMT

Table of Contents