Electromagnetic Compatibility (Emc) - NURIS TRACTOR User Manual

ELECTROMAGNETIC COMPATIBILITY (EMC)

This machine has been designed in accordance with all relative directives and norms. However, it may
still generate electromagnetic disturbances that can affect other systems like telecommunications
(telephone, radio, and television) or other safety systems. These disturbances can cause safety
problems in the affected systems. Read and understand this section to eliminate or reduce the amount
of electromagnetic disturbance generated by this machine.
WARNING: This machine has been designed to operate in an industrial area. To operate in
a domestic area, it is necessary to observe precautions to eliminate possible
electromagnetic disturbances. The operator must install and operate this equipment as
described in this manual. If any electromagnetic disturbances are detected the operator
must put in place corrective actions to eliminate these disturbances.
Before installing the machine, the operator must check the work area for any devices that may
malfunction because of electromagnetic disturbances. Consider the following:
•
Input and output cables, control cables, and telephone cables that are in or adjacent to the
work area and the machine.
•
Radio and/or television transmitters and receivers.
•
Computers or computer-controlled equipment.
•
Safety and control equipment for industrial processes.
•
Personal medical devices like pacemakers and hearing aids.
•
Equipment for calibration and measurement.
•
Check the electromagnetic immunity for equipment operating in or near the work area. The
operator must be sure that all equipment in the area is compatible. This may require additional
protection measures.
•
The dimensions of the work area to consider will depend on the construction of the area and
other activities that are taking place.
Consider the following guidelines to reduce electromagnetic emissions from the machine.
•
Connect the machine to the input supply according to this manual. If disturbances occur if may
be necessary to take additional precautions such as filtering the input supply.
•
The output cables should be kept as short as possible and should be positioned together.
•
If possible, connect the work piece to ground to reduce the electromagnetic emissions. The
operator must check that connecting the work piece to ground does not cause problems or
unsafe operating conditions for personnel and equipment.
•
Shielding of cables in the work area can reduce electromagnetic emissions. This may be
necessary for special applications.
4
12/2021 Rev. 1.0