Remote Transmitters; Remote Transmitter Layout - Clarion UNGO MS3001 Installation Manual

Remote Transmitters

Remote Transmitter Layout

Button 1
Button 2
Mode Button
Each system comes with 2 Remote Transmitters, pre-programmed to Arm and Disarm the
system with chirp confirmation using Button 1 .
Button 1 Arms and Disarms the system. This Button also locks and unlocks the doors when the
system is in Valet Mode.
Button 2 controls the system's Auxiliary Function 1.
When the Arm/Disarm Button is pressed together with any other Transmitter Button, the system
will Arm or Disarm silently (without chirp confirmation).
If the system was programmed to arm without chirp, pressing Buttons 1 and 2 together will arm the system with
chirp.
The Mode Button will change the function of Buttons 1 and 2 when it is pressed, allowing
Auxiliary Fuction 2 to be acessed.
Note also that the LED on the transmitter changes color when the Mode Button is pressed to
indicate the current function of Buttons 1 and 2. The LED will stay on for 5 seconds, then turn
off, returning Buttons 1 and 2 to their off settings.
It is also possible to set individual Remote Transmitters to arm and disarm the system using any
of the Transmitter's function buttons, which is extremely useful when a Transmitter is used to
control multiple systems. See Adding a New Transmitter into the System.
The button assignment of Arming and Disarming will not affect the operation of the Remote
during Programming, Shock Sensor Adjustment, or any other system set-up function. The
buttons used to control those features will remain as they are described in this manual,
regardless of how the Transmitter is set up to arm and disarm the system.
LED
MS3001 / MS3200 Installation Manual - Page 11