Jumper Settings - Clarion UNGO MS3001 Installation Manual

4-Pin Auxiliary Function Harness
Pin 1 - YELLOW/black: Auxiliary Function 2 (-) output.
Provides a negative output to activate a relay. The output of this wire can be set to operate
in one of two operating modes. See Jumper Settings .
Momentary
Latched
Possible uses of the latched output include: audio system valet, auxiliary lighting control,
headlight operation, etc.
Pin 2 - ORANGE/blue: Alarming / Horn Honk (-) output.
Provides a negative output when the system is triggered to activate a relay. The output is
selectable for continuous or pulsed operation. See Jumper Settings.
This wire can be connected to a relay to honk the vehicle's horn, or activate an auxiliary
siren or air horns when the system is triggered.
Pin 3 - BLACK/white: Dome Light (-) output.
Illuminated Entry/Exit output. Provides a negative output to activate a relay to turn on the
vehicle's dome light when the system is disarmed and when the ignition key is turned off.
See Jumper Settings.
Pin 4 - VIOLET/ yellow: Warn Away (-) input.
Connect to the negative Warn Away output from an optional sensor.
Other Harnesses
For details on the Status LED and Override Switch, see Mounting Components .
Battery Back-up Siren (MS3200)
RED: Connect to constant +12v
BLACK: Connect to chassis ground
ORANGE: Positive (+) input, connect to the MS3200 Orange wire
ORANGE/blue: Negative (-) input, * not used*
For proper operation, the red and black wires must be connected. If either the red or black
wires become disconnected, the siren will sound.
Extra LEDs
Up to 3 extra LEDs can be added. Cut the Red LED wire and connect in series as shown.
LED
Connector
Page 8 - MS3001 / MS3200 Installation Manual
- provides output for as long as the transmitter button is pressed.
- provides an output that stays active until the transmitter button is
pressed again.