Reference Chart; Full Time System Diagnostics - Clarion UNGO MS3001 Installation Manual

Reference Chart

You can use this chart to quickly identify and interpret the MS3001 / MS3200 system's chirp
indications and LED flashes.
Output
1 chirp
1 + 3 chirps
1 + 4 chirps
2 quick chirps
LED double flashes
2 chirps
1 Long + 1 Short Chirp
no LED flashes
1 LED flash
2 LED flashes
3 LED flashes
4 LED flashes
1 chirp
5 quick chirps
Double chirps
(for 10 seconds)
LED flashing quickly
Two chirps
1 LED flash
2 LED flashes
3 LED flashes
4 LED flashes

Full Time System Diagnostics

The system continuously monitors all protected zones, even when it is not armed, and warns
you if it detects a problem when you turn off the ignition.
1. Turn off the ignition.
2. If the siren chirps twice, the system has detected a problem.
3. The status LED will flash to indicate the zone where the problem has been detected.
1 flash
2 flashes
3 flashes
4 flashes
When
arming
arming
arming
arming
Valet Mode
disarming
disarming
after Tamper Alert
after Tamper Alert
after Tamper Alert
after Tamper Alert
after Tamper Alert
while armed
while armed
1 minute after disarming
ignition key off
ignition key off
after Full Time Sys. Diag.
after Full Time Sys. Diag.
after Full Time Sys. Diag.
after Full Time Sys. Diag.
= door
= Shock Sensor
= optional sensor
= hood / trunk
Status
normal arming
Shock Sensor sensitivity is off
door, hood, or trunk is open
Valet Mode is on
Starter Defeat Activated
normal disarming
Tamper Alert - system was triggered
ignition
door
Shock Sensor
optional sensor
hood or trunk
Warn Away
Dedicated Remote Start Mode
activated
Automatic Rearming
Passive Arming sequence started
Full Time System Diagnostics
door
Shock Sensor
optional sensor
hood or trunk
MS3001 / MS3200 Installation Manual - Page 17