Installation - Fisher & Paykel PROFESSIONAL WB76SPEX1 Installation Manual

Hide thumbs Also See for PROFESSIONAL WB76SPEX1:
Table of Contents

Advertisement

Tip Hazard
This product may tip. Keep children away and
take care. Failure to follow this advice may
result in injury.
• Drawer must be secured in place by supplied
screws.
• Ensure there is a fixed shelf directly above
the drawer if it is not installed under another
product.
Cut Hazard
Failure to use caution could result in injury.
• Take care: some edges may be sharp.
• Do not put fingers in the drawer when closing.
Electric Shock Hazard
Failure to follow this advice may result in
electrical shock or death.
• If the product is damaged, switch the appliance
off and disconnect it from the mains to avoid
possible electric shock.
Weight Hazard
Failure to follow this advice may result in
damage or personal injury.
• Ensure the bottom shelf of the cabinetry can fully
420-630 lb
support the weight of combined appliances.
190-285 kg
 WARNING!
!
 WARNING!
!
 WARNING!
!
WARNING!
!
SAFETY AND WARNINGS
READ AND SAVE THIS GUIDE
WARNING!
To reduce the risk of fire, injury to persons or damage when using the appliance, follow the
important safety guides listed below. Read all the instructions before using the appliance.

Installation

Please make this information available to the person installing the product.
z
The appliance must be installed by a qualified installer, or Fisher & Paykel trained and
z
supported service technician to avoid faulty electrical connection.
Ensure the installation complies with all clearance requirements and applicable standards
z
and regulations.
When installed in combination with a companion product, the companion product can be
z
placed directly onto the appliance. A built-in shelf at the base of the cabinetry must be
able to support the weight of both products.
Ensure the cabinetry is square and level and with correct dimensions.
z
If installing the appliance directly underneath an oven, ensure you do not damage the
z
oven's lower trim. Fisher & Paykel does not accept any responsibility for any damage
resulting from incorrect installation.
Before installing the appliance, inspect for any signs of damage. Do not install or use
z
damaged appliances.
Be careful when stacking the appliances on top of each other to avoid damage to the
z
appliances.
Electrical
All connections for electrical power and earthing must be done by a qualified electrician
z
and must comply with local codes and ordinances.
Before installation, ensure that the voltage and frequency listed on the data plate
z
corresponds with the household electrical supply.
When combining with another appliance, ensure each appliance has its own power outlet.
z
Avoid sharing the power point to prevent accidental switching off of the appliance.
Ensure your appliance is properly grounded (earthed).
z
Connect the drawer to a properly rated, protected and sized power supply circuit to avoid
z
electrical overload.
Do not use an extension cord or a portable electrical outlet device (e.g. multi-outlet outlet
z
box) to connect the drawer to the power supply. Ensure the power supply cord is located
so that it will not be stepped on, tripped over or otherwise subject to damage or stress.
Ensure there is a switched outlet in an easily accessible area within 35 7/16" (900mm) of
z
the centre rear of the product.
Servicing
Do not repair or replace any part of the appliance unless specifically recommended in the
z
user guide. All other servicing should be done by a Fisher & Paykel trained and supported
service technician or qualified person.
Always disconnect the power supply before doing any installation, maintenance or repair
z
work, and cleaning.
If the power supply cord is damaged, it must be replaced by a qualified electrician or
z
Fisher & Paykel trained and supported service technician.
3

Advertisement

Table of Contents
loading

Table of Contents