Device Software Operation Instructions; Sf Measurement; Mt Measurement - µ-Dimension AutoGet Wifi User Manual

AutoGetWifi Intelligent Fiber Endface Microscope
Note:
It is necessary to restart the device after restoring factory settings.
Check the software update: Before updating the software, you need to copy the installer to the SD
card, click Update, and follow the prompts to upgrade. For details, see 3.1.1.
Restore factory settings: Click Restore to restore the system settings, follow the prompts to restart.
Software version information: Displays the current software version number.

3.3Device software operation instructions

3.3.1 SF measurement

In the real-time image display state, press the device measurement button to measure. After the
measurement is completed, the measurement result is displayed. Press the measurement button
again to display the real-time image.
Figure3-6

3.3.2 MT measurement

For image acquisition, it is necessary to match the MT adapter rotary nut mark value 1, 2, 3, and
collect in three stages, and finally display the measurement results of the MT.
The measurement steps are as follows:
19