Table of Contents
Advertisement
AutoGetWifi Intelligent Fiber Endface Microscope
2.3 Hardware operation
2.3.1 Power On/Off
To power on the device, press and hold the
power button till the blue light indicator is on.
2.3.2 Remove the battery
Battery usage:
1.Use a power supply to charge during the shutdown state of the device, and it will take about 4
hours to charge.
2.When the low light of the power indicator is flashing, the equipment needs to be recharged.
Otherwise, the equipment will be automatically shut down after a certain time. In order not to
affect the performance of the equipment and normal use, please charge in time.
3.In the recharging process, the 4 power indicators will blink in sequence. When the four lights
are always bright, the battery is fully charged.
When the battery switch is in the position shown in the figure, the
battery will automatically pop up, then gently push the battery and
then pull it out.
Figure2-1
Figure2-2
10
Advertisement
Table of Contents
