Device Software Measurement Task Setting - µ-Dimension AutoGet Wifi User Manual

AutoGetWifi Intelligent Fiber Endface Microscope

3.2.2 Device software measurement task setting

Click "Setting" on the interface to enter the measurement task setting interface as follows:
Task name
Task type
Task zone name
Task eaiting area
Application settings
Task: The default measurement task cannot be deleted or modified, and the measurement task can
be customized based on the default measurement task.
Type: Measurement task types are divided into SM, MM, SF, MF, and are selected according to
actual measurement requirements.
Scratch, defect application: After checking, the measurement function of the spot or scratch of the
current measurement area takes effect.
Sensitivity: Sensitivity can be adjusted according to the actual image conditions.
Apply: Apply the settings of the current change.
OK: Save the changed settings then exit.
Cancel: Cancel the changed settings and exit.
Task
Delete task
OK to save and exit
Figure3-2
16
Edit task
Increase task
Cancel to save and exit