Table of Contents
Advertisement
AutoGetWifi Intelligent Fiber Endface Microscope
2.3.8 MT adapter use
The rotation nut on the MT adapter marks the values 1, 2, and 3, and the mark values are aligned
with the dots, respectively, and the measurement buttons are used for image acquisition.
NOTE:
1. The installation method of the MT adapter is the same as that of the single fiber adapter.
2. The MT PC adapter is used in the same way as the MT APC adapter.
3 Software basic functions
3.1 Software installation and update
3.1.1 Device software installation and update
1. Copy the software that needs to be updated to the AutoGetWifidevice SD cardroot directory, and
then install the SD card to the AutoGetWifidevice card slot.
2. Start the AutoGetWifidevice and enter the Software Settings - About interface, click Upgrade.
After the upgrade is complete, it prompts you to restart the device.
3. After the reboot is complete, go to the about interface, click Restore factory settings, and follow
the prompts to restart the device. After the reboot is complete, the software update is complete.
Note:
1. If there is no updateable software in the SD card, the system will prompt "No upgradeable version
found in SD Card"
3.1.2 PC software installation and update
The PC software directly double-clicks the installer and installs it as prompted until the installation
is complete.
Figure2-8
14
Advertisement
Table of Contents
