Fisher & Paykel DD24SDFTX9 Troubleshooting Manual page 5

Problem
Drawer interior is stained
Dishes did not dry
Program is taking much
longer than usual
Excessive motor noise
https://producthelp.fisherpaykel.com/us/Clean/DishDrawer%E2%84%A2/Single/DD24SDFTX9/User_Guide_DD24SDFTX9/06...
Possible Cause
incorrectly loaded.
Some foods, like tomato
based products, may stain
the inside of the drawer
Incorrect loading.
Dishes were left in the
drawer for several hours
after a wash.
Rinse aid depleted.
Rinse aid setting too low.
Normal Eco/Eco program
used.
Items that require a longer
drying time, e.g. plastic
utensils and containers
Wrong type of detergent
used. Auto recovery
program has been
triggered to stop the
dishwasher overflowing
and to disperse excess
foam.
No water in the motor
area.
What to Do
Pre-rinse dishes before placing in the drawer.
Alternatively, using the Rinse program after adding
the dishes may minimise staining.
Ensure the dishes are not nesting together.
We recommend unloading the dishes within a few
hours after a wash program has finished, as the
small amount of vapour left after the wash may -
with time - resettle on dishes as condensation. Using
rinse aid or increasing its setting may also help with
drying.
Refill the rinse aid dispenser.
Increase the rinse aid setting.
Choose a different wash program.
Some models only: Set the wash program with
Extra dry. (only available on some wash programs).
No action required. Allow the program to finish.
You may need to run your
chosen wash program
again with the correct
detergent if the dishes are
not clean at the end of the
recovery program.
This usually occurs on the first use or when the
dishwasher has not been used for long periods of
time. Pour 3 cups of water into the drawer before
running a wash program.
Updated: Tue, 16 Nov 2021 11:16:45 GMT
Powered by
5