Fisher & Paykel DD24SDFTX9 Troubleshooting Manual page 2

Problem
Hard water
Foaming
Water leaking
Dishwasher does not
recognize when I knock on
the door to pause or unlock
https://producthelp.fisherpaykel.com/us/Clean/DishDrawer%E2%84%A2/Single/DD24SDFTX9/User_Guide_DD24SDFTX9/06...
Possible Cause
Wrong type of detergent
used
Incorrect amount of
detergent.
Too much egg left on
plates.
Rinse aid setting too high.
Rinse aid dispenser plug
not closed properly
Drain hose disconnected
from waste pipe.
Water inlet hose not
properly connected.
Other leaks.
Rinse aid dispenser plug
not closed properly
Not knocking hard enough.
What to Do
Increase the rinse aid setting and the amount of
detergent. See section 'Water hardness and
dishwashing'.
Models with built-in water softener ('H' models only):
Increase the water softener setting. See section
'Water softener'.
Models without built-in water softener: If living in an
area with very hard water, consult a plumber on
installing a household water softener.
ONLY use dishwasher detergent. See 'Adding
detergent'.
See section 'Wash programs and detergent
quantities' or follow the detergent manufacturer's
instructions
Rinse off excess egg prior to loading. Increase the
amount of detergent.
Decrease the rinse aid setting.
Ensure that the rinse aid dispenser plug is fully
closed, with its hand grip pointing vertically. See
section 'Using rinse aid'.
Reconnect the drain hose to the waste pipe.
Ensure the inlet hose is connected securely
Turn water and power supplies to the dishwasher
off. Call Customer Care or your Authorised Service
Centre. See your 'Service and warranty' booklet for
contact details.
Ensure that the rinse aid dispenser plug is fully
closed, with its hand grip pointing vertically. See
section 'Using rinse aid'.
Ensure you are knocking firmly on the door, rather
than using a light tap.
Updated: Tue, 16 Nov 2021 11:16:45 GMT
Powered by
2