Fisher & Paykel DD24SDFTX9 Troubleshooting Manual page 4

Problem
Fan noise coming from the
dishwasher after a wash
program has finished
Fan noise starts up when I
close the drawer, even
though I didn't start a new
wash
No powdered detergent
dispensed
The wash program seems to
have finished (the
dishwasher is idle), but the
end of wash beeps haven't
sounded and the drawer
cannot be opened
Water pooling on inner rim
of drawer after a wash
Water under the drain filter
Excess water in the drawer
Water marks on the dishes
https://producthelp.fisherpaykel.com/us/Clean/DishDrawer%E2%84%A2/Single/DD24SDFTX9/User_Guide_DD24SDFTX9/06...
Possible Cause
/
button not pressed.
Dishdrawer is in
"Showroom mode".
This is normal. The drying
fan continues to run for a
set period of time after a
program has finished to
assist with drying.
This is normal. In some
cases, the drying fan will
run whenever the drawer
is closed for a set period of
time after a program has
finished.
Detergent dispenser was
wet when loaded.
The wash program is still
in progress. It is in a 'quiet'
phase that is needed for
ensuring the best wash
results.
This is normal
condensation.
This is normal and needs
no action.
Drain hose(s) bent or
kinked.
Blocked filters.
Rinse aid depleted.
Rinse aid setting too low or
off.
Dishwasher overloaded/
What to Do
/
button.
Contact Customer Care.
No action required. The fan will automatically stop
after the set time is over, or when the drawer is
opened. In some cases, the fan may resume when
the drawer is closed again.
No action required. The fan will automatically stop
after the set time is over
Clean the dispenser and ensure it is dry before
adding detergent.
No action required. The program will transition into a
more audible phase after the 'quiet' phase is over.
Wipe dry.
Straighten the drain hose(s).
Clean the filter plate/drain filter. Refer to 'User
maintenance instructions'.
Refill the rinse aid dispenser.
Increase/turn on the rinse aid setting.
Refer to the section on loading.
Updated: Tue, 16 Nov 2021 11:16:45 GMT
Powered by
4