Connections; Minidisplay Ports; Dual-Usb 3.1 Gen2 (900Ma Each); Standard Pin Assignment - E.E.P.D. Getting Started Guide Device Reference Manual

Connections

MiniDisplay Ports

Standard pin assignment

Fig. 10: MiniDisplay port schematic

E.E.P.D. GmbH | Gewerbering 3 | 85258 Weichs
Copyright © 2021 by E.E.P.D. GmbH. All rights reserved. | Rev.1.2
EM PRO midi E Device Reference Manual – P – Revision 1
Important Note:
There are two kinds of DisplayPort cables available:
Cables for direct connection to a MiniDisplay Port monitor
with Pin 20 on both ends of the cable NOT connected.
Cables for use with dongles (e. g. MiniDisplay Port to Display
Port, MiniDisplay Port to HDMI) with Pin 20 on both ends of
the cable connected.
Possible effects if wrong cable is used:
- System might not start up properly.
- Dongle doesn't work properly (e.g. black display).

Dual-USB 3.1 Gen2 (900mA each)

Standard pin assignment

Fig. 11: Dual-USB 3.1 Gen2 detail

17