Flywoo CineRace20 ANALOG PRO Manual page 9

FLYWOO CineRace20 ANALOG PRO V1.0
2/ Insert the R9M TX module and write the firmware you need
3/ To write the firmware of the R9MM receiver, you need to remove the R9MM receiver, and
then write the firmware by connecting to the S.PORT port.
4/ After both R9M TX and R9MM RX are written into the ACCST firmware.
Binding method:
1/ Press and hold the button of RX, power on, the red and green lights are always on.
2/ Then after R9MM selects binding, RX red light flashes, and then exit
3/ RX is powered on again, and only a green light is displayed, indicating that the binding is
successful.