Advertisement
Quick Links
Advertisement
Related Manuals for Flywoo Firefly 1S Nano BabyQuad
Summary of Contents for Flywoo Firefly 1S Nano BabyQuad
- Page 1 FLYWOO Firefly 1S Nano Baby ANALOG V1.0 Firefly 1S Nano Baby Quad Manual...
-
Page 2: Specification
Firefly 1S Nano Baby Quad is an 20g ultralight 1S Quad for freestyle and crusing. Pilots can enjoy up to 8 minutes and 45 seconds flight time with Flywoo's latest 1S 450mah ! Through a lot of tests, we found the best configuration for Firefly 1S nano baby quad！ It is not only suitable for cruising super long flight time, but also perfect for freestyle like a ripper.Last but not least, it is very quiet, like a mosquito, suitable for both indoors and... - Page 3 FLYWOO Firefly 1S Nano Baby ANALOG V1.0 2/ Configuration and wiring diagram description Flight control wiring diagram PID and filter settings...
-
Page 4: Frequency Table
FLYWOO Firefly 1S Nano Baby ANALOG V1.0 Default serial port settings UART1: TBS/R9M/XM+/DSMX/SBUS receiver UART2: VTX IRC/SA Control Frequency table：: Tip: Image transmission control can only be controlled by IRC 3/ Receiver binding SPI D8 RX: Binding method: 1 / Open Remote Control D8 Protocol Binding Mode... - Page 5 FLYWOO Firefly 1S Nano Baby ANALOG V1.0 TBS NANO 915: When the USB is connected, the green light of the receiver flashes, and then bind according to the picture operation. https://www.youtube.com/watch?v=-iNkVcOLITM&ab_channel=Danimal3D ELRS 2.4G RX: Bind procedure: - Supply power to the EL24E/EL24P rx, wait until the LED on the RX is off, immediately turn off the power, and then repeat again the above steps.
- Page 6 FLYWOO Firefly 1S Nano Baby ANALOG V1.0 3-1/ Then set the corresponding serial port and receiver protocol to ensure the normal output of each channel of the receiver. 4/ Mode setting: Set the ARM switch and flight mode switch, AUX* corresponds to the remote control...
- Page 7 FLYWOO Firefly 1S Nano Baby ANALOG V1.0 5/ Motor test: Unload the propeller, test the rotation direction of the motor, turn on the safety switch, and test the rotation of the motors one by one. 6/ Flight firmware upgrade and write default CLI...
- Page 8 FLYWOO Firefly 1S Nano Baby ANALOG V1.0 Driver software: https://impulserc.blob.core.windows.net/utilities/ImpulseRC_Driver_Fixer.exe 3/ Then load the local HEX firmware and wait for the flashing to complete. A green progress bar is displayed to indicate completion, and DFU will become a COM port...
- Page 9 FLYWOO Firefly 1S Nano Baby ANALOG V1.0 5/ If the command is not restarted after writing the command, please write SAVE and press Enter to save, and the FC will restart 6/ Then all functions of FC return to normal.