Nameplate Information; Interface Definition; Product Information - Zmotion ZMIO300-4AD Manual

Hide thumbs Also See for ZMIO300-4AD:

Hardware manual (56 pages)

Table Of Contents

Table of Contents

The person who conducts the wiring of this product must be trained in

the knowledge of electrical equipment;

When wiring, the external power supply used by the system must be

disconnected before operation. If not all disconnected, it may cause

electric shock or equipment failure or malfunction;

The terminal cover that comes with the product must be installed when

Danger

powering up and running after the wiring work is completed. If the

terminal cover is not installed, there isMay cause electric shock;

The cable terminals should be insulated to ensure that the insulation

distance between the cables will not decrease after the cables are

installed on the terminal block. Otherwise it may cause electric shock or

equipment damage.

When wiring, avoid metal chips and wire ends falling into the ventilation

holes of the expansion submodule, which may cause fire, failure, and

misoperation

The specifications and installation methods of the external wiring of the

equipment should meet the requirements of local power distribution

regulations;

The cable connection should be performed correctly after confirming the

type

the

connected

note

connectedWrong port or wiring may cause module or external device

failure;

Make sure that the cables pushed into the terminals are in good contact.

If the cable is not pressed tightly, it may cause short circuit, fire or

malfunction;

Do not bundle the control wires and communication cables with the main

circuit or power supply wires, etc., the wiring should be separated

100mmOtherwise, noise may cause malfunction.

 4. Product information

ZMIO300-4AD/ DAExpansion submodule hardware manual Version 1.1

interface.If

the

wrong

connection