Zmotion ZMIO300-4AD Manual page 6

10 NC
11 I+
12 V+
13 VI-
14 SG
15 I+
16 V+
17 VI-
18 SG
19 E+ 24V
20 EGND
Wiring

Input port wiring
It can be connected to both voltage input and current input.
Figure 5 Voltage input (left)And current input (right)Wiring diagram
Output port wiring
Image 6 Wiring diagram of output port
Power consumption calculation example

ECATThe external power supply of the communication module is 24V, the internal
ZMIO300-4AD/ DAExpansion submodule hardware manual Version 1.1
- Set aside
Output Channel 2 I+
Output Channel 2 V+
Output Channel 2 V-/ I-
- Safely
Output Channel 3 I+
Output Channel 3 V+
Output Channel 3 V-/ I-
- Safely
power supply 24V power input
power supply 24VPower ground
coupler supplies 5V to each module, and the maximum output is 2A. In addition to the 1.6W
internal power consumption of the ECAT communication module itself, it can also provide
8.4W to each expansion sub-module. Refer to the system power consumption of each
module in the following figure.
ZMIO300- ZMIO300-
ZMIO300-ECAT
4AD
4 inputs 4 outputs
EtherCATCoupler Expansion Expansion
submodule submodule
1.6W 0.4W 0.3W
One ECAT communication module can expand up to 8 4AD/ DAExpansion sub-module,
the actual power consumption is4.8W or so. Please use this as a reference to determine
the number of expansion submodules.
Fault indication and countermeasures

Status Indicator
POW RUN ERR
bright bright bright
The extension submodule
bright Extinguish Extinguish
ZMIO300- ZMIO300-
4DA 4AD 4DA
4 inputs 4 outputs
Expansion Expansion
submodule submodule
0.4W 0.3W
the reason Solution
EtherCATThe
Check whether the local
communication between
expansion
the slave station and the
loose;
expansion submodule is
Restart the power.
interrupted
Check
pre-scanned by the connected
module does not sub-module is lost or
completely match the malfunctioning;
actual extension Check if hot swap occurs;
submodule Restart the power.
ZMIO300-
...
4AD
4 inputs
Expansion ...
submodule
0.4W ...
interface is
whether the
expansion