Citizen iDP-3210 User Manual page 60

(38) Data Input Control (ESC = n)
Code : [1B]h + [3D]h + n
* {0
Selecting equipment in which data input from the host is effective.
l
Each bit of n indicates as follows:
BIT
0
1
2
3
4
5
6
7
l
When the printer has not been selected, this printer abandons all received data until it
is selected by this command.
l
Even when the printer has not been selected, it can become BUSY state through printer
operation.
l
The initial value of n is "1".
(39) Aligning the characters (ESC a n)
Code : [1b]h + [61]h + n
* {0
All the printed data within one line are aligned in the specified position.
l
Depending on n value, positional alignment is carried out as in the table below:
n (Hex)
0
1
2
l
This is valid only when n is inputted at the beginning of line.
l
The initial value of n is "0".
(40) Full Cut (ESC i)
Code : [1B]h + [69]h
Full cutting of paper is performed.
l
This is valid only when n is inputted at the beginning of line.
(41) Partial Cut (ESC m)
Code : [1B]h + [6D]h
Partial cutting of paper is carried out.
l
This is valid only when n is inputted at the beginning of line.
CITIZEN
n FF} Data is described in Hex code.
EQUIPMENT
Printer
Not defined
Not defined
Not defined
Not defined
Not defined
Not defined
Not defined
n 2} Data is described in Hex code.
POSITION
Left end alignment
Centering
Right end alignment
VALUE
0 1
Invalid Valid
60
iDP-3210 User's Manual