Citizen iDP-3210 User Manual page 52

(17) Selecting International Characters (ESC R n)
Code : [1B]h + [52]h + n
* {0 n 0A)
Selecting international characters.
l
Depending on the value of n, following character sets are specified.
l
The initial value of n indicates the character set specified by the dip switch.
However, setting is available only through use of this command for "Spain ", "Norway",
and "Denmark II".
(18) Setting of paper end detector available for output of paper end signal
Code : [1B]h + [63]h + [33]h + n
*{0 n
Specifying the condition of paper end detector to stop printing operation.
l
n is valid only for the lowest bit. (n0)
l
n bit means the followings.
n0
0
1
Remarks : This is valid only for parallel interface model.
(19) Setting of paper end detector available for print stop
Code : [1B]h + [63]h + [34]h + n
* {0 n FF} Data is described in Hex code.
Specifying the condition of paper end detector to stop printing operation.
l
n is valid only for the lowest bit. (n0)
l
n bit means the followings.
n0
0
1
CITIZEN
Data is described in Hex code.
n(Hex) CHARACTER SET
0
1
2
3
4
5
6
7
8
9
A
FF} Data is described in Hex code
Condition
Paper near end disable (initial value)
Paper near end enable
Condition
Paper near end disable (initial value)
Paper near end enable
U.S.A.
France
Germany
U.K.
Denmark 1
Sweden
Italy
Spain
Japan
Norway
Denmark 2
52
iDP-3210 User's Manual