Citizen iDP-3210 User Manual page 53

(20) Enabling/Disabling Panel Switch
Code : [1B]h + [63]h + [35]h + n
* {0 n FF} Data is described in Hex code.
Selecting the paper feed switch valid/invalid.
l
"n" is valid only in the lowest bit (n0).
l
"n" bit means the followings.
n0
0
1
l
The initial value of n is "0".
(20) Printing and Feeding the paper by n lines (ESC d n)
Code : [1B]h + [64]h + n
*{0 n
Prints data inside the buffer and feeds paper by n lines.
l
Specified line does not remain.
l
The beginning of the line is to be considered as the next printing start position.
(21) Generating specified Pulse (ESC p m n1 n2)
Code : [1B]h + [70]h + m + n + n2
* {m = connector pin No. (See table below.)}
Signals specified by n1, n2 are output to Connector Pin m.
l
Bit m (m0) means the followings.
m0
l
ON time is considered as n1 x 2ms and OFF time as n2 x 2ms.
l
When m is out of the defined range, n1, n2 are discarded, where no signals are output.
l
Drive duty of Drawer is shown below:
ON time
ON time + OFF time
(Take OFF time as being 4 times or more longer than ON time.)
(22) Selecting Character Code Table (ESC t n)
Code : [1B]h + [74]h + n
* {0 n 1} Data is described in Hex code.
Selecting Page n on the character code table:
l
"n" means the followings.
n (Hex)
l
The initial value of n is specified by dip switch setting. (DS1-5.6.7)
(Other than Japanese character is specified, IBM #2 is specified.)
CITIZEN
(ESC c 5 n)
Condition
Paper feed SW valid.
Paper feed SW invalid.
FF} Data is described in Hex code.
{0 n1 FF}
{0 n2 FF} Data is described in Hex code.
0 Drawer kick No. 2 pin
1 Drawer kick No. 5 pin
0.2
0 IBM Character #2
1 Japanese Character
Condition
Condition
53
iDP-3210 User's Manual