Citizen iDP-3210 User Manual page 54

(23) Transmitting the printer status (ESC v)
Code : [1B]h + [76]h
Current printer status is transmitted..
l
Status sent out consists of 1 byte whose content is as in the table below.
l
In DTR/DSR control, after receptible state of the host (DSR signal being in SPACE state)
is confirmed, only 1 byte is transmitted. In XON/XOFF control, DSR signal state not being
confirmed, only 1 byte is transmitted.
l
In DTR/DSR control, when the host is in unreceptible state(DSR signal being in
MARK state), it waits until receptible state is created.
BIT
0
1
2
3
4
5
6
7
Remarks. This command is valid only for serial interface model.
(24) Transmitting the status of Peripheral Equipment (ESC u n)
Code : [1B]h + [75]h + n
* {n = 0}
Current status of connector pin No.3 is transmitted.
l
"n" means the followings.
n (Hex)
0
l
Status transmitted consists of 1 byte whose content is as in the table below.
l
Any equipment has not been connected to this connector, Bit 0 of n is always "1".
l
In DTR/DSR control, after receptible state of the host (DSR signal being in SPACE state) is
confirmed, only 1 byte is transmitted. Further, in XON/ XOFF control, DSR signal state
not being confirmed, only 1 byte is transmitted.
l
In DTR/DSR control, when the host is unreceptible state (DSR signal being in MARK state),
it keeps waiting until receptible state is created.
BIT
0
1
2
3
4
5
6
7
(Remarks) This command is valid only for serial interface model.
CITIZEN
FUNCTION
Not defined
Not defined
Paper end
Not defined
Not used
Not defined
Not defined
Not defined
Condition
Drawer Kick Connector No. 3
FUNCTION
Level of pin No. 3
Not defined
Not defined
Not defined
Not used
Not defined
Not defined
Not defined
VALUE
0
With paper Without paper
Fixed to 0
VALUE
0
"L" "H"
Fixed to 0
54
iDP-3210 User's Manual
1
-
1
-