PC Chips M932LR User Manual page 29

Quick Boot
If you enable this item, the system starts up
more quickly be elimination some of the
power on test routines.
1 st Boot Device
Use these items to determine the device
order the computer uses to look for an
2 nd Boot Device
operating system to load at start-up time.
3 rd Boot Device
Try Other Boot
If you enable this item, the system will also
search for other boot devices if it fails to find
Device
an operating system from the first two
locations.
S.M.A.R.T. for Hard
Enable this item if any IDE hard disks support
the S.M.A.R.T. (Self-Monitoring, Analysis and
Disks
Reporting Technology) feature.
BootUp Num-Lock This item determines if the Num Lock key is
active or inactive at system start-up time.
Floppy Drive Swap
If you have two diskette drives installed and
you enable this item, drive A becomes drive B
and drive B becomes drive A.
Floppy Drive Seek If you enable this item, your system will check
all floppy disk drives at start up. Disable this
item unless you are using an old 360KB
drive.
Password Check If you have entered a password for the
system, use this item to determine, if the
password is required to enter the Setup Utility
(Setup) or required both at start-up and to
enter the Setup Utility (Always).
Boot to OS/2 > 64MB
Enable this item if you are booting the OS/2
operating system and you have more than
64MB of system memory installed.
L2 Cache Leave these items enabled since all the
processors that can be installed on this board
have internal L2 cache memory.
System BIOS If you enable this item, a segment of the
system BIOS will be copied to main memory
Cacheable
for faster execution.
Graphic Win Size
This item defines the size of aperture if you
use a graphic adapter.
3: BIOS Setup Utility
25