Functions - Icom IC-F3 Instruction Manual

3
DEALER-PROGRAMMABLE FUNCTIONS
I Functions
In the following explanations, programmable function names
are bracketed, the specific switch used to activate the func-
tion depends on programming.
D D KEYPAD LOCK FUNCTION
This function locks access to all programmable switches (ex-
cept the switch assigned the lock function).
To toggle the lock function ON and OFF:
Push and hold the [LOCK] switch for 1 sec.
•
" "appears while the lock function is ON.
• This function may be inhibited on some channels.
D D PRIORITY CHANNEL
This function is used to select a pre-programmed channel at
the push of a switch.
To select the priority channel:
Push the [PRIORITY] switch.
• "PRIO" appears briefly, then the priority channel is automatically se-
lected.
4
D D SCAN FUNCTION
The scan function allows you to search a pre-programmed
group of channels for signals.
To start/stop scan:
Push the [SCAN] switch.
• Scan pauses on a channel when receiving a signal.
• Depending on programming, a message may appear while scan-
ning.
• "Lockout SCAN" (pre-programmed list SCAN) or "Priority SCAN"
can be pre-programmed.
• When the "Power-save function" is activated, the transceiver checks
all pre-programmed channels then returns to the "Power-save func-
tion" again.
D D BEEP FUNCTION
This function provides confirmation beep tones when push-
ing switches.
To toggle the function ON and OFF:
Push the [BEEP] switch.